36 9.1 The selectivity diagram dialog window. 28 8.2 Adding new protection devices, wizards. 21 6.5 Creating tolerance characteristics. 20 6.4 Specifying standard characteristics. 20 6.3 Numerical input of characteristic points. 19 6.2 Graphical input and editing of characteristics. 18Ħ The characteristic editor.19 6.1 The dialog window. 17 5.3 Saving the diagram or copying to the clipboard. 13 4.2 Editing of protection device data. 12Ĥ Integration in the interactive graphic. 10ģ The independent program E_SelModul.exe.11 3.1 General. 10 2.3 Functions of the interactive graphic E_E32.exe. 9 2.2 Functions of the independent E_SelModul.exe module. 8Ģ The new selectivity module.9 2.1 Installation.

Bahnhofstrasse 40 CH-8703 Erlenbach Switzerland Phone: +41 1 914 36 66 Telefax: +41 1 991 19 71 E-mail: Internet: 1988-2000 Busarello + Cott + Partner Inc, Erlenbach, Switzerland. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose without the express written permission of Busarello + Cott + Partner Inc. Information in this document is subject to change without notice and does not represent a commitment on the part of Busarello + Cott + Partner Inc. )/Type/Annot/AP>endobj425 0 obj/ProcSet>/Type/XObject/BBox/FormType 1>stream This manuscript should be cited as IEEE Transactions on Applied Superconductivity, submitted 2008.

Short circuit analysis code in neplan